OWL-19 ADS-B receiver, 19 inch subrack module
TYPE 2470

OWL-19 ADS-B Receiver

  • 19" subrack system for indoor rack mount and cabinet installation
  • rendundant configuration in one subrack (optional)
  • Subrack per DIN EN and IEC 60297-3-100
  • Module cassette per DIN EN and IEC 60297-3-101
  • 100 VAC to 250 VAC power input, optional DC power input.
  • Operating temperature 0 °C to +50 °C
  • Humidity up to 85%
  • For climate-controlled equipment rooms, technical cabinets and shelters
OWL-N ADS-B receiver, outdoor unit
TYPE 2460

OWL-N ADS-B Receiver

  • Standalone outdoor unit for wall or mast mounting
  • Horizontal mounting on 19" rack shelf (2U)
  • Horizontal mounting on an aircraft ARINC 404 / ARINC 600 tray
  • Die-cast aluminium enclosure, IP65
  • Operating temperature -40 °C to +40 °C
  • Humidity up to 100 %
  • PoE - power over ethernet
  • For unsheltered, exposed installation sites without climate control

Shared specifications — OWL-19 & OWL-N

Frequency
1090 MHz (Mode-S / ADS-B)
Reception range
Up to 400 km, 220 NM
(antenna position and site-dependent)
Message rate
Up to 1.700 messages / second
Target tracking
Up to 400 simultaneous air targets
MTBF
> 50,000 h (calculated)
Signal level
≤ -93 dBm
Signal processing
Multi-phase demodulation, preamble detection, CRC verification, single-bit error correction
GNSS time reference
PPS (Pulse Per Second) disciplined by multi-constellation GNSS including GPS, GLONASS, Galileo, and BeiDou
Network output
Ethernet (RJ45)
RF input
N-type, 50 Ω
Duty cycle
Designed for continuous 24/7 operation
Data output formats
BEAST (binary), JSON, ASTERIX CAT021, ASTERIX CAT025, GOST R 59971-2021
Mode-S downlink formats
DF0, DF4, DF5, DF11, DF17, DF18, DF20, DF21
Bias-tee
+5 V over the RF input, for LNAs / active antennas
Supported MOPS versions
DO-260, DO-260A, DO-260B
Standards
EUROCAE ED-129B, ICAO Annex 10 Volume IV, GOST R 59971-2021
Applications
ADS-B ground stations, WAM & MLAT networks, UAV tracking, training and research

Both variants can be configured to individual customer requirements — for example without bias-tee output where no LNA is used, or with an external power supply instead of PoE or a power-supply cassette.

Accessories

Antennas, amplifiers & mounts.

Compatible components for both OWL-19 and OWL-N. Operation with third-party antennas and LNAs is also possible.

Low noise amplifier Type 14048 for mast mounting
TYPE 14048

Low Noise Amplifier

Mast-mounted LNA, compensates for cable loss on longer antenna runs.

1090 MHz receive antenna Type 15048 and 15148
TYPE 15048 / 15148

1090 MHz Antenna

Dedicated receive antennas for ADS-B / Mode-S reception at 1090 MHz.

Documentation

Looking for the datasheets?

Full technical datasheets for OWL-19 and OWL-N are available in the downloads library.

Go to Downloads →

Specify a system, or bring us a problem to solve.

Get in touch.